ccnp switch chapter 8 exam answers

ccnp switch chapter 8 exam answers

1,10,20,30 !! In the case of turning off VTP prunnig , trunk defaults to traffic for all VLANs , which is in SW2 The default is 10 , this default value is generally sufficient. Route-map test permit 20 match ip address 2 Recognized as a self-determination attribute. LP is the local priority and is used for Update messages between internal peers ( IBGP ) , but not to other EBGP neighbors. The larger the LP value, the higher the priority. Complete the basic interface IP configuration . Add the following configuration on R2 : Due to the different port types,ccnp switch chapter 8 exam answers, the switch processes the frames differently. The following is introduced according to different port types. We spotted FIG, R1 and R2 between runs RIP to exchange routing information, R2 by RIP learned the R1 release over 192.168.1.0/24 and 2.0 / 24 routing information loaded into the routing table, labeled R & lt . While R2 and R3 and running OSPF , establish OSPF adjacency, R2 also from R3 , by OSPF learned the two routes: 3.0 and 4.0 / 24 , is also loaded into the routing table, labeled O . So, for R2 , it has its own route to the whole network, but inside R2 , we can understand this : it will not change the route learned from RIP .The OSPF route is told to R3 , and the route learned from OSPF is not sent to R1 as a RIP route . For R2 , although there is complete routing information in its own routing table, it is as if there is a gap between the entries of R and O , which cannot be exceeded.