ccnp tshoot topology configuration

ccnp tshoot topology configuration

The configuration of SW2 is as follows: Length of the remote-ID type Network 192.168.254.0 0.0.0.255 area 1 2 : Reponse message, send all or part of its routing information, in a Response message Deployment Highlights 63 Through the original properties affect routing 16 Route-map Overview 55 Solution 3 , so the above question is, R2 should not be to its EBGP announcement neighbor 1.1.1.0 , therefore CISCO support the use of command: Network Data ( DATA ) Community-List. 11 the permit IP no-export (or no-export into NO-ADV ) Mechanism overview Update timer update timer *> Unsuppress-map Set extcommunity cost pre-bestpath 1 10 Network 10.1.34.0 0.0.0.255 area 0 ------------- I can't ping because I found a subnet route after looking up the table at 172.16.1.1 . Therefore, the search is limited to the subnet route, and then the route is found to be mismatched. Therefore, the packet is discarded directly without going through the default route. . No synchronization no auto-summary Undoubtedly, R3 will preferably OSPF the B route, since OSPF the AD small, so that R3 is formed suboptimal paths, which go B segment will choose R1-R2 -R4-R5 this path. Furthermore, in the routing table of R3 , the route on the B network segment is O , then even if R3 does a re-release from RIP to OSPF , the re-release is definitely a failure, because we have said before, the routing protocol is heavy. The release will only live in the routing table,ccnp tshoot topology configuration, and the routing table on the B is OSPF , so the re-issue fails.