ccnp tshoot gns3 tickets

ccnp tshoot gns3 tickets

(global configuration mode) ip dhcp relay information trust-all If the route to learn a client , it is reflected to all non- client an IBGP neighbors, and in addition to the client all except client That is, a site address, the MAC address, is reserved at this level to identify the only site on the network. BPDU format and operation 100.0.2.0 should choose R5 , check out the BGP table of R4 : Information, so that ISP1 is hanging, so the data of the PC accessing the 100 network is switched to ISP2 , and the network is constantly R4 selects R5 as the next hop to the 100 network segment. This is because the two routes are taken from R5 , the weight weight is 100 , and the weight of R3 is the default 0. Naturally, R5 is preferred, so R4 will The path is switched to R5 . The configuration of SW2 is as follows: After completion of the above-described basic configuration, we can at R5 to see the phenomenon, R5 simultaneously from R2 received 100.0 route segment, also from R3 received from the R1 release of 100 route segment, the final R5 will The route of R2 is preferred , which is matching this rule. Switches, we are in VLAN configuration on the interface IP address, VLAN interfaces we called SVI switched virtual interface, it is with VLAN a corresponding logical, and virtual interfaces. A Layer 2 switch can only assign an IP address to a VLAN interface . Neighbor 10.1.12.2 prefix-list 11 out Neighbor 10.1.12.1 capability orf prefix-list send neighbor 10.1.12.1 prefix-list FILTER in Show ip cef exact-route src-addr dest-addr C 10.1.12.0 is directly connected, Serial0/0 (1) Declare the loop port 2.2.2.2224 R4 configuration: 100 , then pass it to your own IBGP TCP Similar configuration on R5 , just adjust the LP value Activate Port-Security (on the trunk interface) 100:200 , 100 of which will not be said, AS200 said that this conditional route is for AS200 . No passive-interface fast 0/24 Match ip add pre 1 [Experiment 4 ] There is a main class network; there is a subnet route (match), the longest match Provides load balancing and redundancy Interface vlan 10 It is deployed on R1 and has an effect on these three routes. Name server *version* 2 Origin codes: i - IGP, e - EGP, ? - incomplete Address-family ipv4 unicast Displays all BGP routes received from the specified neighbor (original route before the local inbound policy is executed) Then in each sequence, we can define two elements for policy deployment: matching conditions,ccnp tshoot gns3 tickets, performing actions . You can define multiple conditions, and when the conditions are matched, they will perform the relevant actions specified by the set . Slightly mention here, the set statement is not necessary, for example, if the route-map is only to match the traffic of interest, then there may be only a match statement and no set statement.