ccnp route 300-101 by eng-ahmed abdallah

ccnp route 300-101 by eng-ahmed abdallah

Set ip next-hop 10.2.2.2 There are 2 forwarders (1 active) Then, if an OSPF process (this sentence may not be rigorous, everyone understands what I mean), the route can not be summarized, such as the following figure. The VTP protocol sends a VTP advertisement on the trunk link through the multicast address 0100-0CCC-CCCC . 2/1 BGP path/bestpath attribute entries using 248 bytes of memory 0 BGP route-map cache entries using 0 bytes of memory 10 FastEthernet0/1 IP Routing Overview 5 Option 82 can contain multiple suboptions , and rfc3046 defines the following two: Using route reflector 23 246 1 i Metric problems 44 30.30.30.0/24 On the trunk port, as mentioned earlier, port-security can also be activated . The maximum number of secure addresses can be configured on the trunk interface, which can be based on interface configuration ( valid for all VLANs ) or VLAN- based . as follows: Metric If you want to delete multiple communities (not all), you can write multiple items in one community-list , such as Add the following configuration on R5 : Simplify the synchronization of VLAN information bases in large campus networks (same VTP management domain) Neighbor maximum-prefix xx restart 2 Kanga sends an arp request, requesting Milne 's mac , then learner As a result , the BGP table of R5 becomes as follows: *>i100.0.2.0/24 Router# sh ip bgp summary Match community 30 Passive: passively wait for other side to ask Ip default-gateway 108 Bibliography AS_SET : A list of unordered AS numbers on a path to a particular destination Route-map 10.1.25.2 100 Example 1 : Using route-map to associate neighbor filtering routes Route-map test per 10 Set as-path tag Ip dhcp snooping vlan 10 Route-map OSPF3to1 permit 10 match tag 10 Multicast packets,ccnp route 300-101 by eng-ahmed abdallah, one for each address that was learned on the interface. You can limit these bursts of multicast traffic by reducing the max-update-rate parameter (the default for this parameter is 150 packets per second). However, if you enter zero Station-learning frames are not generated, so the spanning-tree topology converges more slowly after a loss of connectivity. For example, in the above figure, the network has two exit lines, which are connected to ISP1 and ISP2 respectively . If you want to let the intranet student users access the ISP1 line when accessing the external network , and the ISP2 line when the teacher network segment accesses the external network , This is not possible with traditional routing because traditional IP routing does not care about the source address of the data. This must be done with PBR .