ccnp route 300-101 eigrp

ccnp route 300-101 eigrp

(Note that this feature is not supported in truncated switching mode on 6509 switches ) Set ip next-hop { ip-address [...ip-address] | recursive ip-address } In RIPv1 based on the increase Match ip address prefix-list 1 2 Router ospf 1 The configuration of the DHCP server is a general configuration and will not be described here. Write multiple commums in the same line, such as ip community-list 1 permit no-export 12:1111 does not take effect, can not delete these two values BGP table on R7 : As a result, R3 updates the BGP route to R4 ,ccnp route 300-101 eigrp, and next-hop will be replaced with R3 's loopback interface IP . Complete the basic configuration Note that the neighbor 1.1.1.1 filter-list x weight yyy command can be used multiple times for a neighbor, that is, set different weights for different routes . But the neighbor 1.1.1.1 filter-list 1 command, in the same neighbor in or out direction, can only be used once, these two commands are very different Configuration command CAM table [Results] There is only 1.1.1.0 route in the routing table on R2 . We will find that when the topology changes, the TCN will be generated . However, in some cases, the transition flooding of the TCN may have an unnecessary impact on the network . The interface connected to the PC terminal device on the access layer switch is set to portfast network can be optimized to a certain extent, prevent the PC interface of the switch due to switch updown and excessive the TCN .