ccnp tshoot exam 300-135

ccnp tshoot exam 300-135

Is 6 , then the type is 802 , default ethernet RIP Message Format The secure address formed by the dynamically learned MAC is valid. If the MAC is in a failed state within 50 minutes (for example, the host is offline), the secure address is cleared after the aging time expires. Network without mask is a class declaration, plus the mask is no class declaration On a specific interface,ccnp tshoot exam 300-135, if no BPDUs are received for three consecutive cycles (or max-age timeout), the STP data on the interface will age rapidly. As a result, the BPDUs are somewhat similar to the keep-alive mechanism between switches . This fast aging mechanism helps to respond quickly to topology changes. It is actually an order with the following, so knocking in, show has become the following stuff. RIPv2 manual summary R3 and R4 update the routes in AS1 and AS2 to R5 and R6 at the same time . If R5 is required to go to AS1 , take route R3 and go to AS2 . *>i100.0.2.0/24 On R1 , ip route 1.0.0.0 255.0.0.0 null 0 then ip defaut-network 1.0.0.0 , then R2R3 will learn the default route R2(config)# access-list 1 deny 192.168.3.0 R2(config)# access-list 1 permit any R2(config)# router ospf 1 Knowledge review The basic interaction process is as follows (the process described below is independent of the above diagram): The traditional STP , which is 802.1D , is that all VLANs share a spanning tree. The advantage of this is that the switch does not use too much resources to calculate multiple spanning trees. However, the defect is that the port is fixed through the block . As a result, traffic on the network only goes to one side, and some links have no traffic at all, which wastes bandwidth. Then use set comm-list 1 delete to delete, pay attention to the above community-list writing, use multiple lines, the experimental verification results are in 100 Switch(config-if)# switchport access vlan 10 R1(config-route-map)# match ip address prefix-list list1 the Next-Hop recursive This (recursive next hop ) broke the characteristics of the traditional hop-hop interface must be directly connected under the router IP restrictions. Recursive next-hop may not be directly connected to the network, as long as the relevant routes in the routing table are reachable. Generally, the recursive next-hop is unreachable, and the data will be handled by the route (generally the default route is matched).