ccnp tshoot 300-135 cbt nuggets

ccnp tshoot 300-135 cbt nuggets

1.1.1.1 (metric 65) from 1.1.1.1 (1.1.1.1) 2. Pass the RIP update with an unnumbered address ( invalid source ) Write multiple commums in the same line,ccnp tshoot 300-135 cbt nuggets, such as ip community-list 1 permit no-export 12:1111 does not take effect, can not delete these two values Must be a zero field. 10.1.34.3 from 10.1.34.3 (3.3.3.3) Packets with destination addresses that do not exist at the beginning of 192.168 are discarded directly. Normal traffic on other subnets of the 192.168 intranet will be forwarded according to the longest matching principle. Switchport access vlan 100 interface fast0/24 Length of the circuit-ID type s> 172.16.1.0/24 Precautions: Manually shut down a specific port and then noshutdown Ip address 10.1.25.5 255.255.255.0 We restore the experimental environment to the basic configuration: BGP neighbor relationships are as follows Bgp confederation identifier 345 bgp confederation peers 64512 neighbor 4.4.4.4 remote-as 64512 Exclude one or more addresses from the address pool (such as gateway IP, etc.) to avoid assignment to clients Experimental needs 100 i Alternate port: Discard status. In addition to the root port and other ports to the root path, if the active root port fails, the replacement port becomes the root port, so the alternate port can be understood as an alternative to the root port. At the same time network 1.0.0.0 , then 1.0.0.0 will be announced UDLD mode of operation When the DAI discards an ARP packet, the switch stores a message in the log buffer , and then generates a system message system information. After the system information is generated, the switch clears the previously stored entries from the log buffer . Each entry contains information such as VLAN , port number, source destination IP address, and source destination MAC address . Weight Ip route 2.2.2.0 255.255.255.0 192.168.13.1 Neighbor 1.1.23.2 send-community Not used (set to all 0s ) Three-layer bundle Detailed rules Another way is to use ARP ACL : 1 3.3.3.3 Vlan 10 Must be a zero field. Origin codes: i - IGP, e - EGP, ? - incomplete CAM and TCAM We can affect the routing by setting the LP value. For example, the same implementation allows R4 to access 100.0.1.0 and go to R3 , accessing 100.0.2.0. If R1 turns on auto-summary and network 1.1.1.0 mask 255.255.255.0 , it is still updated to R2 with details. SW3 receives this BPDU , but finds that this BPDU is less preferred than its own locally stored BPDU , so the BPDU is ignored. R1 release A network routing, R3 will learn this OSPF routing; Additionally, R2 also learned, assuming R2 deploy OSPF to RIP routes redistributed, which eventually route R3 will pass RIP also learned, then R3 will At the same time , the route is learned from RIP and OSPF . R3 will optimize the OSPF route. Because OSPF has a small AD , OSPF re-releases it to RIP without causing a suboptimal path problem.