ccnp 300-101 practice exam

ccnp 300-101 practice exam

Redistribute static Again, the following topology, the phenomenon is the same as above, pay attention to the summary route using the as-set keyword, the AS_PATH of the underlying detailed route will be put into {} , which is AS_SET . Paths: (2 available, best #2, table Default-IP-Routing-Table) Not advertised to any peer Matches the preceding character 0 times or 1 occurrences State is Listen TYPE DHCP-SNOOPING VERSION 1 Preemption enabled, min delay 30 sec The oldest EBGP neighbor means that it is probably the most stable BGP neighbor, so it is preferred here. Of course, this rule has poor controllability and is generally not used as a routing policy. The following happens and will skip this rule: CAM and TCAM R2(config-router)# distribute-list 1 out If the routes are from EBGP neighbors, it is preferred that the oldest EBGP neighbor came routing, reduce the impact of the roll (this provision mainly EBGP //Get out a summary route instead of the default route basic concept Knowledge review Vlan 10 FastEthernet0/0 If the route is imported using the aggregate-address command, the MED is empty. None uses the distribution list or the access control list deny 521 port. 0xFFFF By modifying LOCAL_PREF to affect the flow properties : ccnp 3.3.3.3 Accept either real AS or local AS from the ebgp peer . Translation: EBGP peers can use either PriAS or SecAS to local remote-as . For example, after configuring the above command on R2 , R3 is 10.1.23.3 . In its BGP process, you can use neighbor 10.1. 23.2 remote-as 200 , you can also use remote-as 201 to refer to BGP neighbor R2. Enhanced Interior Gateway Routing Protocol (EIGRP) Open Shortest Path First (OSPF) Router(config-router)# distance AD ip-src wildmask acls Vlan 10 R1 and R3 , R2, and R5 establish an EBGP neighbor relationship. Locally find a route to the neighbor, and start preparing for TCP connection and monitoring remote peer Passive-interface configuration 51 Ip prefix-list FILTER deny 1.1.1.0/24 ip prefix-list FILTER permit Port Security : Enabled Portfast,uplinkfast,ccnp 300-101 practice exam, backbonefast Show ip route dhcp Displays routes added to the routing table by DHCP Router(config)# router ospf 1 The IBGP neighbor relationship is as shown in the figure. The neighbors are built using their respective loopback ports. After receiving the route, R2 continues to pass the IBGP neighbor R3 . In this case, R3 is the RR . Therefore , the route sent by the non- client IBGP neighbor is forwarded to its client R4 . At this time, R3 adds the ORIGINATOR and CLUSTER_LIST attributes to the route. , where the ORIGINATOR attribute is R2 's routerID is also 2.2.2.