ccnp route 300-101 kevin wallace pdf

ccnp route 300-101 kevin wallace pdf

10.1.13.1 Advertise-map Catos port switch ID in the default priority 32 (priority . 6 th 'bit ) , the IOS switch default 128 (priority field . 8 bits) 3.3.3.3 Ip community-list 1 permit no-export ip community-list 1 permit 12:1111 Note: If it is an EIGRP environment, you need to implement unicast update, then the route update interface can not be PASSIVE (this is different from RIP ), directly use the neighbor command to specify the neighbor. If the interface is PASSIVE , even if the neighbor is manually specified , the EIGRP neighbor relationship cannot be established normally . 802.1q 0 , regarded as infinity switchport trunk encapsulation dot1q switchport mode trunk Modify the default value of the MED value Sw(config-vlan)#private-vlan community Router ospf 100 Passive-interface configuration 51 If the route is marked d , it means that the route is suppressed. If it is h , it means that the route has signs of flipping. 802.1q CISCO default MED is 0 Access-list 1 permit any route-map PBR permit 10 match ip address 1 RFC1723 defines several compatibility switches Match abcd , abccd , abcccd, etc. <100-500> Community list number (expanded) expanded Add an expanded community-list entry Knowledge point ? Must be zero 10.1.13.3 ? A frame whose type field is 0806 represents an ARP protocol frame. RIPv1 , v2 Bgp confederation identifier 345 bgp confederation peers 64513 neighbor 3.3.3.3 remote-as 64512 2> Dynamic inbound soft reset The program seems to be able to solve the problem,ccnp route 300-101 kevin wallace pdf, but brought new problems, first of all to R1 , for example, R1 by way of re-release of the introduction of 1.1.1.0 , the route through BGP updated way to the R2 , R3 , R4 ( accessed through multiple links), this time on these routers, 1.1.1.0 route original was - incomplete ; and in order to achieve the above requirements, R2 in its local network of 1.1.1.0 , this coming, 1.1.1.0 in R2 When a local route is imported into BGP and the AD value becomes 200 , R2 advertises 1.1.1.0 to its EBGP neighbor , and its advertisement 1.1.1.