ccnp rs exams

ccnp rs exams

Preferably , the routes sent by the EBGP neighbors (relative to the IBGP neighbors) are preferred to the EBGP routes in the EBGP and IBGP . Note that the first six rules in the BGP routing rules cannot be determined. Only in case of circumstances. Switchport access vlan 10 interface fast0/24 Layer 3 interface: routing interface ( no swithport or called routed port ), SVI interface Network consolidation (same protocol or different protocols) Identify the type of message: Configure the switch to verify that the source MAC address in a DHCP packet received on untrusted ports matches the client hardware address in the packet. The default is to verify that the source MAC address matches the client hardware address in the packet. B 3.3.3.0 [200/0] via 2.2.2.2, 00:03:01 In the above figure, the configuration revision number of server and client is the same, but the vlan information is different. At this time,ccnp rs exams, an error will be reported, prompting md5 digest checksum mismatch access-list 1 deny 172.16.32.0 0.0.0.255 In fact, this is more a problem, because such an approach, in fact, the last 8 bit group no matter what, will be live match, he is even more imprecise. Federal configuration and implementation EIGRP , BGP and other dynamic routes learned. Configuration BGP federal 25 OSPF re-advertises routes to IBGP 17:57:27 Finally note: ? The route originated from the local route (such as the local network or aggregate ), that is, the next hop is 0.0.0.0 ( in the BGP table , the next hop of the route advertised by the current router is 0.0.0.0) Metric problems 44 Address family 3.3.3.3 On the catalyst switch, you can use the portfast keyword to manually configure it. The link has failed. Can also be understood as the maximum life of this BPDU , the default 20S Bridge ID in the MAC , is the backplane of the switch MAC , the port ID in the MAC switch port MAC , all the view switch mac available Ip route 192.168.10.0 255.255.255.0 fast 0/0 Limit the host connected to the switch port ( filtered according to IP or MAC address) So match interface is a match with the outbound interface attribute, and this Use the err-disable command to modify the duration of the err-diasable state. The default is 300S. Number of existing VLANs 8 Do not advertise to any peer (well-known community) Do not export to next AS (well-known community) After " 10.1.20.0 " is passed to R2 , since the updated subnet is consistent with the R2 interface main network, R2 receives the update, and uses the interface mask /23 as the mask of the received RIP subnet, then R2 local loading This RIP route is 10.1.20.0/23 . In fact, the prefix length of the route is wrong. We can configure a secondary address on the R2 interface. In this way, RIP will use the mask of the secondary address (if configured) to receive the route. For example, configure R2 with 10.1.123.222/24 .