ccie lab update
-
- 9848 Reviews
1. reduce the routing table Large Small 2. accelerate yield convergence 3. limiting prepared LSA diffuser dispersion 4. The improved stability
Configuration is consistent .
experimenting with bottles and cans for four years. After graduation, I
Blocking -> Listening -> Learning -> Forwarding
Action :
Division of the domain ( interval ).
Ip host
Ipv6 nat v4v6 source 192.168.1.2 2001::3
6:30 AM Get up
The location of the extended access control list application : the application is closest to the source
/64 SLA Site-Level Aggregation
Now to refuse the thief to come in from A, then you have to set up in your living room, there are 2 ways:
=========================================================== ===============
A(config-if)#ip rip authentication mode md5
was that the network problem in the company had mcse. Can screw up.
B(config-if)#ip nat outside
Fix: I think, this is not to let me PASS, then reconfigure and fix it.
0x2142 bypass plus carrier startup-config process ,ccie lab update, either : not load the startup configuration , directly into the setup mode
(5) People are divided into groups
problem through the written test, 2002 At
4.0.0.0
experiment, and Save all experimental experimental configurations and then digest them.
Transparent Firewall Essentials
Transport layer: Provides traffic control, error control, and acknowledgment services for the network. Act as an interface to web applications.
B(config)#inte s 1
The third stage: One hour after I knocked the version, the next girl went out. Then I came back to cry. When I came out, I glanced at version 3. I said, "Come on, don't give up." I don't know if there is any encouragement! !
Ip ospf x area x (overlay behavior)
EIGRP uses a wildcard mask configuration example :
Ip address 2001::1/64
5. Why do you want to encapsulate header information at each layer of the TCP/IP stack?
4, work experience such things, in fact, it is really not important here, because for the study and examination, the people who walk, most of the time are OK, no one, even if there is work experience, most of the time No way;
Debug ppp authentication
I
Immediate execution , immediate effect
R1(config-if)#no cdp enable
Password cisco
R14(config-if)#encapsulation ppp
the network world, and also participated in several product conferences
5. Why do you want to encapsulate header information at each layer of the TCP/IP stack?
=========================================================== ===============
2. Advertise the network of this interface to other routers
To solve the horizontal separation, you can use the sub-interface method.
PAT configuration
2. Switch to bridge the number of segments ( ports ) have the number of collision domains .
Database, analyzes the impact of OSPF type 1, type 2, and metric on routing, NSSA
“The black belt represents the beginning – the starting point for the endless process of tempering, striving and pursuing higher standards.”
Rommon3>IP_SUBNET_MASK=255.255.255.0 (mask of the router)
Configure the S1 interface as the outside network.
A section of configuration:
However, it is often the case that the files that the user is transferring contain not text files, they may be programs, databases, word processing files or compressed files. Use the binary command to tell ftp a verbatim copy before copying any non-text files.
View history commands ( commands that have just been used recently )
2.CHAP: Challenge-style three-way handshake , password mining with HASH transmission algorithm , than P A P stronger
B(config)#inte s 1
~When I saw the mail at around 5 pm, the result of the "closed" was passed. I didn't know what to say except the tears. I immediately called my wife: "Wife, I passed." It turns out that as long as you plan well and implement it unswervingly, it will move in the direction you expect, and then you will work harder. That will surely be "waterful."
face the difficulties. Many
=========================================================== ===============
Ipv6 route 2002::/64 serial 1/0 (next hop address)
interface command, knowing that ccie is the highest certification in
Mainly use two kinds of packets of ICMPV6: NS neighbor request, NA neighbor advertisement
Vlan 10 name cisco
Console baud: 9600
Show ipv6 route
Destination filename ? C3825-spservicesk9-mz.150-1.M.bin (target file name)
week. I don’t think that God would let me pass. It must be that I have
ccie exam failed for the first time, and my mentality was adjusted for a
Site local site local
2. The data link layer : data error detection , physically address MAC
This question is left to you to answer, hehe
DM*** I didn't have any "fragile ingredients" when I did it. It was just a casual down, just add IPSEC.
Encapsulation frame-relay
2. Tunnel technology IPV6 communication between IPV6 networks (main), IPV6 communication between IPV4 networks
GW: 192.168.26.2
Just as I was about to withdraw, after the trace of the phenomenon, I found that the original nine jumps became ten jumps. I am going! !
PS: The actual situation is about 10 minutes earlier than the scheduled one. . . . . The night before, I basically woken up every hour during my sleep at night, but it was good to sleep at 8 o'clock, and it was OK to add up.
=========================================================== ===============
++<6> + x
=========================================================== ===============
1.IPV6 address format
(The above information is what I saw on a website about the Internet, including information about CCIE routing and switching, security, wireless, big data, etc., I recommend you to visit)
12. Why do the backbone network pop and metro network exits be next-hop-self?
Configuring and Verifying Time Settings
Not so with no shutdown activation command port
The router discovery function of the neighbor discovery process completes the stateless automatic acquisition of IP.
Check to see EIGRP topology database ( table )
Application of withdrawal and the VLAN database configuration mode
Configure the S0 interface as an inside network.
Assigned for this sub-specific interfaces of PVC. ??? is a PVC number .
Kai on the interface with the HDLC:
Chong was built VLAN
The third stage: One hour after I knocked the version, the next girl went out. Then I came back to cry. When I came out, I glanced at version 3. I said, "Come on, don't give up." I don't know if there is any encouragement! !
There are a lot of soft powers, such as: communication, talk, manners, presentation, tenacity, hard work, etc. You are handsome and beautiful, everyone’s soft power is different, find it, play to the extreme, Remember that “to make up for shortcomings is always more difficult than to carry forward the advantages.”
Agreement :
When the IOS failure is not available or the command erase flash is used accidentally, there are two ways to upgrade IOS.
Troubleshooting method 2: Enter the monitor mode input: (note the case)
B(config)#inte s 1
Source filename ? C3825-spservicesk9-mz.150-1.M.bin (the name of the IOS to be upgraded)
Troubleshooting OSI Layer 3 and Layer 4 Inspection
Static Routing
(-c is a valid test, c3825-spservicesk9-mz.150-1.M.bin is the IOS image file stored on the PC)
There are three working modes of the switch: 1. Store and forward - the data is stored in the buffer, and the CRC cyclic redundancy check is performed. If the packet has a CRC error, the packet is discarded. 2. The straight-through exchange is read-only. The first 6 bytes are searched for the destination address through the address mapping table and then transmitted to the corresponding port. 3. Fragment Discarding - A solution between the first two to check whether the length of the packet is 64 bytes. If it is small, if it is large, it will be forwarded.