Free Cisco Written Dumps
For Top 50 Purchases 01:59:56
X
CCIE Routing and Switching LAB Dumps
Exam Code: CFG: LAB1、LAB1+、LAB2、LAB2+、LAB3
TS: TS1(5 sets)、TS2(3 sets)
DIAG：DIAG 1~DIAG 8（8 sets）
Certification Provider: Cisco
Certification Exam Name:CCIE Routing and Switching Lab
Update Date: Apr 18,2024
Latest Dumps
Numbers of Question & Answers
Numbers of Question & Answers
- 9182 Reviews
ccie r&s lab equipment list
200:0:0:EFA:0:0:0:ABCD Lab 4-1: Configuring MPF, Basic Stateful Inspections, and QoS Enter privileged mode Use the appropriate algorithm , such as (SPF) to calculate the best route trigger update I OSPFv3 specifies that a port can participate in multiple processes. R6(config-if)#ip address 1.1.1.1 255.255.255.0 =========================================================== =============== Look at the picture and see the configuration. ----- s1 RA s0 >-------- s1 RB s0 --------- s1 RC s0 ------ =========================================================== =============== 3. The source address of the protocol packet in RIPng is the link-local unicast address. Network 192.168.1.0 0.0.0.3 NA: Source IP is 2001::1 Destination IP is FF02::1:FF00:0001 4 silent timing controller 5. trigger updating Password cisco Dynamic state N A T configuration WAN type and encapsulation protocol : Configuring and Verifying EtherChannel R14(config)#access-list 1 permit any With home VTP Third, do not easily restart some important equipment, this is not recommended. Because there are likely to be some unexpected situations! ! 1. TCP/IP model and OSI model. feel that the whole systemized thing has not been straightened out. I Access-list 1 deny host 10.3.3.1 Debug ip igrp transactions =========================================================== =============== X.x.x.x has always been useless, and finally checked the English CD for a long time, finally knowing the Cisco NO series command, this is my first debugging experience. I was thrilled by the moment of Internet access! A series of doubts about myself since the university have been swept away. In the IPV6 transition technology: there are 5 types of tunnels 3. Safety : different of VLAN communication Tone test igrp related events PVC: permanent virtual link The location of the extended access control list application : the application is closest to the source Ppp chap password cisco Master Wu Xue is waiting for him to say something. Obviously he is not satisfied with the apprentice's answer. Finally he spoke up: "You haven't gotten to take the black belt. Come back a year later." 2. Implement packet filtering and opening my own computer company. There Frame 1. Standard Access Control List 1-99, 1300-1999 Permit Talking about the ability of high-paying network engineers obstacles and still unswervingly cut. Under Login Three ways for IPV6 terminals to obtain addresses: ability is forced out, depending on whether you have such B(config-if)#ip nat inside Zhuangzi said: "You are too bad at using big things! Song Guo has a person who is good at making anti-hand cracking medicine. His family has been relying on important things for generations to rinse." One guest heard, willing He paid a hundred gold to buy his prescription. He then summoned his own people to discuss and said: 'We have been washing the silk for generations, but the income is not a hundred dollars. Now I can sell this medicine and I will get a hundred gold. Please allow me to sell it to him. "When the guest gets this prescription, he goes to lobby Wu Wang. At this time,ccie r&s lab equipment list, the Vietnamese troops sent troops to invade Wu, and Wu Wang sent him to lead the enemy. In the winter, he fought against the country and defeated the army. Wu Wang then Mark the land to give him a gift. The function of the prescription for cracking is the same. Some people use it to get a reward, but some people just use it to rinse the silk. This is because the party’s use is different. Now you have five stones.
ccie r&s lab equipment list
Here is the most accurate CISCO CCIE WRITTEN exam questions and answers. All study materials need to be carefully selected by professional certification experts to ensure that you spend the least amount of money, time, and pass the high quality exam. There is also a professional service team that can customize your study plan for you to answer all your questions, PASSHOT's CCIE Written Dumps is definitely the biggest boost for you to test CCIE that helping you pass any Cisco exam at one time.
SECTION 1 LAYER 2 TECHNOLOGIES
Section 1.1: LAN Access
The following requirements were pre-configured
l VTP is turned off in all switches
l All required VLAN, including access-ports configuration in all relevant switches are provisioned.
l All required SVI interface in all relevant switches (including IP address and subnets mask) are provisioned.
Configure the network in all sites as per the following requirements:
l Access-port must immediately transition to the forwarding state upon link up, as long as they do not receive a BPDU. Use the minimal number of commands per switch to enable this feature.
l If an access-port receive a BPDU, it must automatically shutdown. Use the minimal commands per switch to enable this feature.
l Ports that were shutdown must attempt to automatically recover after 10 minutes.
l None of the switches may generate a TC.
section 1.2: LAN distribution
configure the headquarters’ network as well as the large and medium office networks as per the following requirements:
l all trunks must use dot1q encapsulation
l negotiation of trunking protocol must be disabled in all switches
l distribution switches (SW300, SW301, SW400, SW401, SW500, SW501) must initiate etherchannel negotiation using LACP
l configure layer 2 etherechannel’s number as shown in the ‘diagram 1: main topology’ and ‘diagram 5: layer 2 connections’ (that is use only Po1 and/or Po2)
l ensure that all ports included in etherchannels are effectively in use and bundled in the expected channel
l access switches must see similar output as shown below:
section 1.3: LAN resiliency: spanning-tree
configure the headquarters‘network as per the following requirements:
l SW300 must be the spanning-tree root bridge and must maintain a single spanning-tree instance for the following VLANs: 2000, 2002, 2004, 2006, 2008 (use instance number 2)
SW301 must be the spanning-tree root bridge and must maintain a single spanning-tree instance for the following VLANs: 2001, 2003, 2005, 2007, 2009 (use instance number 1)
l all other VLANs, except 3001, must share the default spanning-tree instance
l ensure that interface E0/2 of SW 300 and SW 301 is a dot1q trunk and that it switches frames for VLAN 3001 only
l SW300, SW301, and SW 310 must not have any blocked ports for any access VLAN (2000-2009)
l SW310 must have the least chance of being elected the root bridge for any VLAN
l none of the three switches may run more than four instance of spanning-tree at any point in time
configure all access switches in both datacenter networks (SW110, SW111, SW210, SW211) as per the following requirements:
l use 32-bit based values for the default port path cost
l all four switches must use the default value for their interface cost
section 1.4: WAN switching technologies
configure the home router R70 as per following requirements:
l the Ethernet WAN link must rely on a layer 2 protocol that supports authentication and layer 3 protocol negotiation
l the service provider expects that R70 completes a three-way handshake by providing the expected response of a challenge requested
l R70 must use the hostname “R70”and password “CCIE” (without quotes)
l R70 must receive an IP address from R8 and must install a default route pointing to 201.99.8.8
l ensure that R70 can successfully ping 8.8.8.8, which is located in the ISP#2 cloud
l you are not allowed to configure any static route in R70 in order to achieve the previous requirements
l use the pre-configured Dialer 1 interface as appropriate
section 2 layer 3 technologies
section 2.1: OSPF in HQ
configure the headquarters network (BGP AS#65003) as per the following requirements:
l both gateway routers of the headquarters network must always advertise a default route into the ospf domain
l all four devices produce the exact same output as shown below. everything must match, except the “dead time” counters and line order
section 2.2: OSPF in DC#1
in order to speed up OSPF convergence in the datacenter#1 network, limit the number of IP prefixes that are carried in OSPF LSAs that OSPF is preconfigured in all required devices in datacenter#1
configure the datacenter#1 network as per the following requirements:
l all OSPF devices must exclude the IP prefixes of connected networks when advertising their type 1 router LSA, except for prefixes associated with loopbacks or passive interfaces
l host loopbacks are the only OSPF intra-area prefixes that may appear in any DC devices ‘routing table
l your solution must still apply if any new interface was added to the OSPF domain
l don not use any prefix-list or another explicit filter anywhere
l do not configure any interface as unnumbered
l do not remove any pre-configuration
section 2.3: B2B connection with partner#1
R100 is located in the partner#1 network and is connected to R42. it supports OSPF only. configure the large office network as per the following requirements:
l R42 must run a separate OSPF process with R100
l as mentioned in item 2.6, the site gateways R40 and R41 area not allowed to redistribute OSPF into BGP and vice versa
l R42 is allowed to redistribute OSPF into BGP and vice versa
At the end of the exam:
l The server 2 (that is located in the Datacenter#2) must be able to ping the IP address 100.100.100.100/24 (that is located in the partner#1 network)
R100, the partner router, must receive the external prefixes as shown below and no other prefixes:
Section 3 VPN Technology
Section 3.1: MPLS VPN
Section 3.2: DMVPN
Section 3.3: Internet Access
Section 3.4 LAN to LAN IPsec
Section 4 Infrastructure Security
Section 4.1: Device Security
Section 4.2: Network Security
Section 5 Infrastructure Security
Section 5.1: System Management
Section 5.2: Quality of Service
Section 5.3: Network Services
Section 5.4: Network Services
RELATED PRODUCTS
